KoCAD · Pantallas y funciones
How to run an engineering study (BETA): frame, plate, thermal and second opinion
The common path of every study: sourced data, supports and loads, Calculate, reading the map, PDF report — and the limits.
Este artículo aún no está traducido a su idioma: se muestra la versión en English.
En esta página
What this is for
Engineering studies give a first answer on strength and deformation without leaving KoCAD. All of them are BETA: linear calculations that help you decide but do not certify capacity. The decision to manufacture stays with the responsible engineer.
- Study (Evaluate tab → Strength) · For
- Structural analysis (frame) · Stress, deflection and utilisation of the members of a weldment; natural frequencies; linear buckling; lighter-profile suggestion
- Plate with a hole (plane stress) · Peak stress at the edge of a hole in a plate under tension (Kt factor)
- Plate bending (pressure) · Deflection and stress of a plate under pressure, with simply supported, clamped or free edges
- Thermal + thermal stress · Temperatures, heat flux and, if asked, the thermal stress
- AI second opinion · A text review of the design, with sources, using your AI
The common path
- Open the study with the model open.
- Sourced data: enter E, ν, allowable stress (and α for thermal) of each material, with the source (standard, edition). Nothing is pre-filled; without data, Calculate is blocked and the reason is shown.
- Supports and loads: choose where it is held (fixed, pin, roller…) and the loads (self-weight, kN/m, pressure, forces).
- Criteria: deflection limit (L/n), minimum buckling factor.
- Calculate: the calculation runs in a separate program, only when you ask; Cancel stops it at once.
- Read the result: choose the map (utilisation, stress, displacement…), use the probe and check the balance of loads and reactions.
- PDF report in Portuguese, Japanese or English, with every input and source.
AI second opinion
It only runs when you ask, with the AI you connected. Before sending you see exactly what goes (design facts and KoCAD results; never the geometry, files or images). The answer is a suggestion with sources: nothing is executed and the AI does not decide geometry, standard or strength.
Common mistakes
- Calculate greyed out: a sourced value or the Confirmed box is missing; the reason shows in red.
- Frame "floating": supports are missing; hold the feet (Support lowest nodes).
- Odd result: check units (kN, kPa, mm) and the gravity direction (+Y).
Related articles
- Structural analysis (BETA): stress, deflection, modal, buckling and lightest JIS profile
- BETA studies: plate bending, heat and thermal stress, frame ΔT and AI second opinion
- Engineering studies (experimental BETA): stability, clearance and motion
- How to build a weldment (tube frame) from sketch to weld