Skip to content

KoCAD · Getting started

Basics: measure, weigh and change a size

Distance between faces, weight from the material and how to change a size after it is done (Dimension / Ctrl+D).

Updated Current version KoCAD 0.43.7PC (Windows etc.)

On this page
▶ Measure, weigh and change a size · 1:21

Measure

  1. Click Measure, then two faces, edges or points of the part.
  2. The distance (and the angle or area when they make sense) shows in the left panel.
The distance between two faces
The distance between two faces

Weigh

Click Weight. If the part has no material yet, pick one (Mild steel, Stainless, Aluminium, Brass, Plastic, Wood). KoCAD shows volume, mass and centre of gravity.

Volume, mass and centre of gravity
Volume, mass and centre of gravity

Change a size (the most common question)

  1. Click Dimension (or press Ctrl+D, or double-click the feature in the tree). The sizes of the part appear, each in a box.
  2. Change the number (e.g. 200 → 250) and apply.
  3. The part rebuilds itself, with the holes and everything that depends on it; the 2D drawing follows.
The part rebuilt with the new size
The part rebuilt with the new size

Was this page helpful?